May 16, 2010

Basics Tutorial: Sewing Binding to Quilt

Before sewing your binding in place on your quilt top, you should carefully prepare it.  Attach your walking foot if you have one, it helps to move all the layers of fabric smoothly under the needle.  


Raw edges lined up, begin with a 12" - 18" tale unattached to your quilt, we will get back to that a little later, sew 1/4" away from the raw edges.
 If you have a needle down position, use it - you will stop and start a lot to adjust the quilt.
 Stop 1/4" away from the corner, and pull your quilt out from under the needle.  Fold the fabric away and back down - I typically just pinch it until all the edges are matching.  
 like so, and continue around your quilt in the same manner, until you are almost back to where you started.   Again leave a tail, and 18" gap, of unsewn binding.  
 Lay your tails overlapping one another in the middle of your gap.  Trim one side to the middle of your gap.
 With your ruler, measure and mark 2 1/2" of overlap.  I use the edge of my ruler - you might take a pencil and mark it.  

 Now cut away excess.  (If you cut your bindings narrower - use that strip measurement for the amount of overlap.)
 Now fold your quilt to make room to work, and arrange binding strips at 90 degrees.
 Here's a closer look - carefully pin, and mark a line corner to corner.
 Because I'm working with the entire quilt, I add a couple or extra pins to keep everything lined up perfectly.  Now sew on the marked line.
Now check to make sure it fits nicely before you trim.  It's been working like a charm for me for a while :)

 Trim away excess 1/4" away from the seam.  And continue sewing your binding in place!
 Before tacking down the binding by hand I press the binding away from the quilt top.  


The quilt pictured is available as a tutorial here.





A couple of friends have great binding tutorials as well, check out:
Em's Scrap Bag
Jaybird Quilts


Let me know if you have questions and I'll answer in the comments for everyone ~
Amy
---------------------------------------------------
Next steps:
Subscribe to Amy's Creative Side
Shop with Amy
Follow Me on Twitter
Become a fan of Amy's Creative Side on Facebook
Email me

5 comments:

Army Wife Quilter said...

thanks I always fold one end at 90 degrees then place the other end inside and stitch. When I hand sew it is really bulky in that place i will try it your way. I cant wait til friday i have a quilt or two i want to put in the festival.

Allie said...

Great tute - that's how I do mine too, it's my favorite way to do a binding. No folding over the ends, it's all finished off perfectly!

Cheryl said...

Nice tutorial, Amy. Great photos! When I sew my binding on I usually position it with the raw edges about 1/8 inch away from the raw edge of the quilt. It makes for a fuller, more stuffed binding. I like your pinching the ends way of doing the corners, too. I will pass your blog on to my new sewing students who want to know how to finish the final strips. That's way beyond the scope of my beginning quiltmaking class. :-)

Lis Harwood said...

Great tutorial Amy - the binding is such an important aspect of the whole quilt and can make or break imho! I wish I was better at it, I'll try your method.

Anonymous said...

Yay, I followed this tutorial right this time! My bind went on great. Thank you so much for this tutorial!